The Flat Earth Wiki
The Flat Earth Wiki
Log in

Difference between revisions of "Astronomical Prediction Based on Patterns"

From The Flat Earth Wiki
Line 18: Line 18:
 
''Motion of the Planets p.138''
 
''Motion of the Planets p.138''
  
{{cite|The Tide Predicting Machine of the Coast and Geodetic Survey at Washington is a note-worthy example of the application of the mechanical method [of prediction via epicycles]. The rise and fall of the tide at any port is a periodic phenomenon, and it may, therefore, be analyzed, or separated into a number of simple harmonic, or circular components. Each component tide will be simple, will have a definite period and a constant amplitude; and each such component may be represented mechanically by the arm of a crank, the length of which represents the amplitude; each crank arm being, in fact, the radius of one of the circles in our diagram. Such a machine was invented by Sir William Thomson and was put in operation many years ago. The machine at present in use at Washington was designed by William Ferrel. It provides for nineteen components and directly gives the times and heights of high and low waters. In order to predict the tides for a given place and year, it is necessary to adjust the lengths of the crank arms, so that each shall be the same proportion of the known height of the corresponding partial tide, and to adjust the periods of their revolutions proportionally to the actual periods. Each arm must also be set at the proper angle to represent the phase of the component at the beginning of the year. When all these adjustments have been made, the machine is started and it takes only a few hours to run off the tides for a year, or for several years. This machine probably represents the highest possible development of the graphical or mechanical method. It is a concrete, definite mechanical adaptation of the epicyclic theory of Hipparchus. But, because the Coast Survey represents and predicts the movements of tidal waters by a complicated mass of revolving cranks and moving chains, does any one imagine for a moment that the actual waters are made up of such a system of cranks? No more did Hipparchus believe that the bodies of the solar system were actually attached to the radial arms of his epicycles; his was a mere mathematical, or graphical device for representing irregular, complicated motions.  
+
{{cite|The Tide Predicting Machine of the Coast and Geodetic Survey at Washington is a note-worthy example of the application of the mechanical method [of prediction via epicycles]. The rise and fall of the tide at any port is a periodic phenomenon, and it may, therefore, be analyzed, or separated into a number of simple harmonic, or circular components. Each component tide will be simple, will have a definite period and a constant amplitude; and each such component may be represented mechanically by the arm of a crank, the length of which represents the amplitude; each crank arm being, in fact, the radius of one of the circles in our diagram.  
 +
 
 +
Such a machine was invented by Sir William Thomson and was put in operation many years ago. The machine at present in use at Washington was designed by William Ferrel. It provides for nineteen components and directly gives the times and heights of high and low waters. In order to predict the tides for a given place and year, it is necessary to adjust the lengths of the crank arms, so that each shall be the same proportion of the known height of the corresponding partial tide, and to adjust the periods of their revolutions proportionally to the actual periods. Each arm must also be set at the proper angle to represent the phase of the component at the beginning of the year. When all these adjustments have been made, the machine is started and it takes only a few hours to run off the tides for a year, or for several years. This machine probably represents the highest possible development of the graphical or mechanical method. It is a concrete, definite mechanical adaptation of the epicyclic theory of Hipparchus.  
 +
 
 +
But, because the Coast Survey represents and predicts the movements of tidal waters by a complicated mass of revolving cranks and moving chains, does any one imagine for a moment that the actual waters are made up of such a system of cranks? No more did Hipparchus believe that the bodies of the solar system were actually attached to the radial arms of his epicycles; his was a mere mathematical, or graphical device for representing irregular, complicated motions.  
  
 
While the graphical, or mechanical method is limited to a few terms, the trigonometrical, or analytical method is unlimited. It is possible to pile epicycle upon epicycle, the number being limited only by the patience of the mathematician and computer.}}
 
While the graphical, or mechanical method is limited to a few terms, the trigonometrical, or analytical method is unlimited. It is possible to pile epicycle upon epicycle, the number being limited only by the patience of the mathematician and computer.}}

Revision as of 04:16, 1 October 2018

Perturbations

https://en.wikipedia.org/wiki/Perturbation_(astronomy)

Special Perturbations

  “ In methods of special perturbations, numerical datasets, representing values for the positions, velocities and accelerative forces on the bodies of interest, are made the basis of numerical integration of the differential equations of motion.[6] In effect, the positions and velocities are perturbed directly, and no attempt is made to calculate the curves of the orbits or the orbital elements.[2] Special perturbations can be applied to any problem in celestial mechanics, as it is not limited to cases where the perturbing forces are small.[4] Once applied only to comets and minor planets, special perturbation methods are now the basis of the most accurate machine-generated planetary ephemerides of the great astronomical almanacs.[2][7] ”


Gravitation Vs. Relativity

by Charles Lane Poor, PhD

Full Text Link

Motion of the Planets p.132

  “ The deviations from the “ideal” in the elements of a planet’s orbit are called “perturbations” or “variations”.... In calculating the perturbations, the mathematician is forced to adopt the old device of Hipparchus, the discredited and discarded epicycle. It is true that the name, epicycle, is no longer used, and that one may hunt in vain through astronomical text-books for the slightest hint of the present day use of this device, which in the popular mind is connected with absurd and fantastic theories. The physicist and the mathematician now speak of harmonic motion, of Fourier’s series, of the development of a function into a series of sines and cosines. The name has been changed, but the essentials of the device remain. And the essential, the fundamental point of the device, under whatever name is may be concealed, is the representation of an irregular motion as the combination of a number of simple, uniform circular motions. ”

Motion of the Planets p.138

  “ The Tide Predicting Machine of the Coast and Geodetic Survey at Washington is a note-worthy example of the application of the mechanical method [of prediction via epicycles]. The rise and fall of the tide at any port is a periodic phenomenon, and it may, therefore, be analyzed, or separated into a number of simple harmonic, or circular components. Each component tide will be simple, will have a definite period and a constant amplitude; and each such component may be represented mechanically by the arm of a crank, the length of which represents the amplitude; each crank arm being, in fact, the radius of one of the circles in our diagram.

Such a machine was invented by Sir William Thomson and was put in operation many years ago. The machine at present in use at Washington was designed by William Ferrel. It provides for nineteen components and directly gives the times and heights of high and low waters. In order to predict the tides for a given place and year, it is necessary to adjust the lengths of the crank arms, so that each shall be the same proportion of the known height of the corresponding partial tide, and to adjust the periods of their revolutions proportionally to the actual periods. Each arm must also be set at the proper angle to represent the phase of the component at the beginning of the year. When all these adjustments have been made, the machine is started and it takes only a few hours to run off the tides for a year, or for several years. This machine probably represents the highest possible development of the graphical or mechanical method. It is a concrete, definite mechanical adaptation of the epicyclic theory of Hipparchus.

But, because the Coast Survey represents and predicts the movements of tidal waters by a complicated mass of revolving cranks and moving chains, does any one imagine for a moment that the actual waters are made up of such a system of cranks? No more did Hipparchus believe that the bodies of the solar system were actually attached to the radial arms of his epicycles; his was a mere mathematical, or graphical device for representing irregular, complicated motions.

While the graphical, or mechanical method is limited to a few terms, the trigonometrical, or analytical method is unlimited. It is possible to pile epicycle upon epicycle, the number being limited only by the patience of the mathematician and computer. ”